BIGTREETECH S2DW V1.0 User Manual

BIGTREETECH S2DW V1.0 User Manual
4
Product Profile
BIGTREETECH S2DW V1.0 is a module for printer resonance compensation. It
can communicate through USB, greatly simplifying wiring.
Feature Highlights
 The board has a reserved BOOT button for easy firmware updates.
 Reserved solder points enable users to customize wiring easily.
 The USB port has an added ESD protection chip to prevent the MCU from
being damaged by static electricity through the USB.
Specifications
Dimensions
33.25 x 15.5mm
Installation Dimensions
See BIGTREETECH S2DW V1.0-SIZE.pdf for
details.
Microprocessor
RP2040 Dual ARM Cortex-M0+ @ 133MHz
Input Voltage
DC 5V
Logic Voltage
DC 3.3V
Communication with PC
USB2.0
Sensor
LIS2DW
Output Rate
1.6Hz-1600Hz
Sensor Communication
4Line SPI
Low Noise
As low as 1.3mg RMS in low power mode.
Sensor Operating
Temperature Range
-40℃ to +85℃
Firmware Support
This product currently only supports Klipper firmware.

BIGTREETECH S2DW V1.0 Specifications

General

Brand	BIGTREETECH
Model	S2DW V1.0
Category	Computer Hardware
Language	English