BIGTREETECH ADXL345 V2.0 User Manual

BIGTREETECH ADXL345 V2.0 User Manual
9
Firmware Update via DFU
Raspberry Pi or CB1 update via DFU.
1. Hold the Boot button and connect the board to Raspberry Pi/CB1 via
Type-C cable to enter DFU mode.
2. Enter lsusb in the SSH terminal to query the DFU device ID.
3. Enter
cd klipper
navigate to the Klipper directory, and enter
make flash FLASH_DEVICE=2e8a:0003
start flashing the firmware (Note: Replace 2e8a:0003 with the actual
device ID found in the previous step.)
4. After flashing, enter
ls /dev/serial/by-id/
to query the device's Serial ID (only applicable for USB communication,
not for CANBus).
5. For USB communication, you don't need to press the Boot button for
subsequent updates. Enter the following command to flash the firmware
make flash FLASH_DEVICE=/dev/serial/by-id/usb-Klipper_rp2040_4550357128922FC8-if00
(Note: replacing /dev/serial/by-id/xxx with the actual ID found in the
previous step).
Configuring Klipper
1. Download the sample-bigtreetech-adxl345-v2.0.cfg config file from:
https://github.com/bigtreetech/ADXL345

BIGTREETECH ADXL345 V2.0 Specifications

General

Brand	BIGTREETECH
Model	ADXL345 V2.0
Category	Computer Hardware
Language	English