BIGTREETECH Octopus MAX EZ V1.0 User Manual

BIGTREETECH Octopus MAX EZ V1.0 User Manual
24
#define POWER_LOSS_RECOVERY // enable power loss recovery
#define PLR_ENABLED_DEFAULT true // true default to power loss recovery
enabled
#define POWER_LOSS_ZRAISE 10 // raise the print head by 10mm after
power loss to prevent the nozzle from touching the printed part
#define POWER_LOSS_STATE HIGH // set signal level, UPS 24V V1.0
returns low level when not triggered and HIGH level when power is cut, thus
this setting needs to be HIGH
RGB
#define NEOPIXEL_LED // enable Neopixel
#define NEOPIXEL_TYPE NEO_GRB // set Neopixel type
//#define NEOPIXEL_PIN 4 // disable PIN setting, use the correct signal pin in
the pin file of the motherboard
#define NEOPIXEL_PIXELS 30 // number of LEDs
#define NEOPIXEL_STARTUP_TEST // the light will show red green and blue
sequentially to self-test

BIGTREETECH Octopus MAX EZ V1.0 Specifications

General

Brand	BIGTREETECH
Model	Octopus MAX EZ V1.0
Category	Computer Hardware
Language	English