BIGTREETECH Octopus MAX EZ V1.0 User Manual

BIGTREETECH Octopus MAX EZ V1.0 User Manual
35
computer using the SSH application.
4. Rename klipper.bin to "firmware.bin", copy to SD card to update firmware.
5. Enter: ls /dev/serial/by-id/ in command line to check motherboard ID to
confirm whether firmware is updated successfully, as shown below.
copy and save this ID, it is needed when modifying klipper config.
Configure Klipper
1. Enter your Raspberry Pi IP address into your browser to open the webUI, find
the reference config for motherboard in the directory shown below, if there is
no such config available, update your Klipper source code to the newest
version or download from GitHub:
https://github.com/bigtreetech/BIGTREETECH-OCTOPUS-Max-EZ

BIGTREETECH Octopus MAX EZ V1.0 Specifications

General

Brand	BIGTREETECH
Model	Octopus MAX EZ V1.0
Category	Computer Hardware
Language	English