BIGTREETECH Octopus MAX EZ V1.0 User Manual

BIGTREETECH Octopus MAX EZ V1.0 User Manual
23
Auto Power Off(Relay V1.2)
#define PSU_CONTROL // enable PSU control to turn on and off using M80 and
M81
#define PSU_ACTIVE_STATE HIGH // set turn on level, Relay V1.2 is turned on
with high level and turned off with low level, so this setting needs to be HIGH.
Power Loss Recovery
There are two methods for power loss recovery
1. No extra module needed, the motherboard will write current print status to the
SD card after every layer is printed, which shortens the life of the SD card
severely.
#define POWER_LOSS_RECOVERY // enable power loss recovery
#define PLR_ENABLED_DEFAULT true // true default to power loss
recovery enabled
2. External UPS 24V V1.0 module, when power is cut, the module will provide
power to the board and signal the board to save current print status to SD
card. This method has virtually no effect on the life of the SD card.

BIGTREETECH Octopus MAX EZ V1.0 Specifications

General

Brand	BIGTREETECH
Model	Octopus MAX EZ V1.0
Category	Computer Hardware
Language	English