BIGTREETECH Octopus MAX EZ V1.0 User Manual

BIGTREETECH Octopus MAX EZ V1.0 User Manual
22
#define GRID_MAX_POINTS_X 5 // set number of probe points for X axis,
usually 5 point is sufficient
#define GRID_MAX_POINTS_Y GRID_MAX_POINTS_X // set the number of
probe points for Y axis to the same as X axis.
If BLTouch also functions as your Z homing sensor, no wiring change is needed,
just set it in the firmware.
#define USE_PROBE_FOR_Z_HOMING // use Z Probe(BLTouch) for Z homing
#define Z_SAFE_HOMING // home Z at the center of print bed to prevent probing
outside of the print bed.

BIGTREETECH Octopus MAX EZ V1.0 Specifications

General

Brand	BIGTREETECH
Model	Octopus MAX EZ V1.0
Category	Computer Hardware
Language	English