BIGTREETECH TMC5160T Plus V1.0 User Manual
11
Safety Instructions
1. Turn off the power before installing the driver to prevent damage.
2. Do not plug or unplug the driver module with power on to avoid damage.
3. Be cautious of polarity when connecting; reversing can cause the driver to
burn out.
4. The factory-installed heat sink should not be removed, as doing so will
decrease heat dissipation in the absence of thermal interface material.
5. For large currents (greater than 3A), active cooling is required for normal
operation.
6. This product uses a 0.022R sampling resistor, so the maximum effective
driving current is 10.6A.
7. Pay attention to the power sequence; ensure the driver power is turned on
before the logic power. That is, turn on the driver power first, then power on
the motherboard.
8. Regardless of whether the driver uses high or low voltage power delivery,
the output voltage from the main control board to the drive must not
exceed 24V; exceeding this will damage the driver.
If you need further resources for this product, you can find them at
[GitHub](https://github.com/bigtreetech/). If you cannot find what you need, you may
contact our after-sales support(service005@biqu3d.com).
If you encounter any other problems during use or have suggestions or feedback, please
contact us. Thank you for choosing BIGTREETECH products.
To Previous Page
Loading...