Bilt Teeter EP-560 - STEP 3 Assemble Table Bed to A-Frame

TOP VIEW
INSIDE VIEW
Figure 9
Figure 10 Figure 11b
Figure 11a
ASSEMBLE TABLE BED TO AFRAME
Failure of the Self-Locking Hooks to close over
both Roller Hinge Pivot Pins is an indication of
improper assembly and if not corrected could
result in serious injury or death!
WARNING
!
Figure 12: Rotate the Table Bed so that it is
facing up. Ensure that it rotates smoothly.
See also Image A on Page 10 to ensure
misassembly has not occurred.
Figure 10: Lower each Roller Hinge Pivot Pin into
the A-Frame hinge plates, one side at a time.
The Self-Locking Hooks will open to allow the
Pivot Pin into the Hinge Plate slot, then
automatically snap closed over the Pivot Pin.
TIP: You may need to push outward on the
Hinge Plate in order for the second Pivot Pin
to lock in place.
Figure 11a & 11b: Make sure that each Pivot Pin is
seated at the base of the slot in the Hinge Plates,
and that the Self-Locking Hooks have closed over
both Pivot Pins.
Figure 9: Face the front of the A-Frame where
the Crossbar is located. Grasp both Roller Hinges,
right above the Cam Lock, and lift the Table Bed.
Allow the top of the Table Bed to rotate toward
the floor, so that the back of the Table Bed is
now facing you and the top of the Table Bed is in
front of the Crossbar.
STEP 3
8
Figure 12