OPERATOR’S MANUAL 81882X
INCLUDING: OPERATION, INSTALLATION AND MAINTENANCE
RELEASED: 8-20-99
REVISED: 11-9-18
(REV: K)
1” DIAPHRAGM PUMP
1:1 RATIO (METALLIC)
READ THIS MANUAL CAREFULLY BEFORE INSTALLING,
OPERATING OR SERVICING THIS EQUIPMENT.
It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.
CCN 99866683
U.S.A. / Canada Customer Service Toll Free Customer Service
195 Internationale Blvd and Technical Support
Glendale Heights, IL 60139 800-992-4657
Tel. 630-237-5000 Toll Free Fax
Fax. 630-237-5011 888-246-5732
SERVICE KITS
Refer to the “Model Description Chart” to match the pump material
options.
862003 for Air Section repair (see page 7).
862020 for replacement of Diaphragms (see page 4).
862025 for replacement of Balls and Seats (see page 4).
862026 (optional) for replacement of Balls and Seats (see page 4).
PUMP DATA
Models ............................ see “Model
Description Chart”
Pump Type ....................... Metallic Air Operated
Double Diaphragm
Material ........................... see “Model
Description Chart”
Weight
Aluminum ....................... 19 lbs (8.62 kgs)
Stainless Steel ................... 28.95 lbs (13.13 kgs)
Maximum Air Inlet Pressure ...... 120 psig (8.3 bar)
Maximum Material Inlet Pressure . 10 psig (0.69 bar)
Maximum Outlet Pressure ....... 120 psig (8.3 bar)
Maximum Flow Rate
(ooded inlet)
... 35 gpm (133 lpm)
Maximum Particle Size ........... 1/8” dia. (3.2 mm)
Dimensional Data ................. see page 9 and 10
Noise Level @ 70 psig, 60 cpm
.. 64.5 dB(A)
Tested with 873275 muer installed.
The pump sound pressure levels published here have been updated to an Equivalent Contin-
uous Sound Level (LA
eq
) to meet the intent of ANSI S1.13-1971, CAGI-PNEUROP S5.1 using four
microphone locations.
GENERAL DESCRIPTION
The Bink’s Diaphragm Pump oers high volume delivery even
at low air pressure. Bink’s pumps feature stall resistant design,
modular air motor / uid sections.
Air operated double diaphragm pumps utilize a pressure
dierential in the air chambers to alternately create suction
and positive uid pressure in the uid chambers, Ball checks
ensure a positive ow of uid. Pump cycling will begin as air
pressure is applied and it will continue to pump and keep up
with the demand. It will build and maintain line pressure and
will stop cycling once maximum line pressure is reached (dis-
pensing device closed) and will resume pumping as needed.
1’’ DIAPHRAGM PUMP
STAINLESS STEEL
PUMP
ALUMINUM PUMP
Figure 1
MODEL DESCRIPTION CHART
81882
CENTER BODY MATERIAL
FLUID CAP / MANIFOLD MATERIAL, THREADS
- Aluminum
SEAT MATERIAL
- 316 Stainless Steel
- Stainless Steel
- PTFE (Optional kit)
BALL MATERIAL
0 - Aluminum, N.P.T.F. - 1
1 - Aluminum, B.S.P.
2 - Stainless Steel, N.P.T.F. - 1
3 - Stainless Steel, B.S.P.
DIAPHRAGM MATERIAL - PTFE / Santoprene
X
To Next Page
Need help?
General
