Earth connection, Binks Part No. 0114-011798
Mount the pump securely and position the pump at a convenient height to allow for maintenance.
Set the pump speed to a slow cycle rate and prime the pump to remove any air before increasing
pressure.
The pump must be earthed at all times. A resistance <1Ω when measuring with an ohm-meter at the
earth point
Set the air regulator pressure to give the desired fluid flow.
The pump inlet pressure should nominally be 1 bar (15 PSI) higher.
This product should be flushed with a suitable compatible solvent prior to use.
Fluid Regulator Air Pilot
Attach flexible hoses to all connections. Connect a regulated air supply to the air connection.
Re-torque end cap nuts to 8 Nm prior to use. Check periodically during use
To Next Page
Loading...
