Binks E2-30 - Smart Control Features

Instruction Manual
Page 13 of 40 Issue: 2.1
N:\Engineering\Manuals\Pump Unit E2-30 & 40 R2.1.doc
Installation – Section 3.2 – Electrical
Smart Control - Optional
The pump can be used in either flow mode or
pressure mode. When Pressure mode is required it
is desirable to use a ‘Smart card’ to control the
functionality of the pump.
The control card has in built software to control the
paint flow rate and system pressure within given
set parameters so that the paint system can be
used in the most efficient way at all times, thus
saving energy consumption.
Smart Control
The ‘Smart’ system design provides for two modes of operation, fully automatic
closed loop pressure control and open loop flow control.-
Detailed Status for 1 Channe
l showing 20L/min flow increase
in the
paint system and the immediate pump speed response increase