Some regulatory agencies prohibit the operation of HVLP spray guns above 10 psi nozzle atomizing pres-
sure. Users subject to this type of regulation should not exceed 10 psi (50 psi gun inlet pressure). See Air
Pressure Recommendations, page 6 and General Spray Instructions, page 4. It is recommended that the
nozzle test gauge (see below) be used to confirm actual nozzle operating pressure.
It may also be a requirement of some regulatory agencies that users have this gauge nozzle available on
site to verify that the gun is being operated within the limits of applicable rules.
IMPORTANT REGULATORY NOTE
AIR NOZZLE TEST GAUGE ASSEMBLY
Part Number Description
54-3908★ 900 Series
54-3935 95, 97P, 95AP and 97AP
54-4066★ 94P Nozzle
54-4078★ 95AS and 97AS Nozzles (Siphon)
54-4345★ 90P Nozzle
54-4356 93P Nozzle
54-4566 96G Nozzle
★
Available from Industrial Finishing distributors only.
59-299 Gauge
8
Part Sheet 2463R-9 Printed in USA 4/03, All Rights Reserved
BINKS WORLDWIDE SALES AND SERVICE LISTING - www.binks.com
INDUSTRIAL FINISHING
Binks has authorized distributors throughout the world. FOR TECHNICAL ASSISTANCE OR THE DISTRIB-
UTOR NEAREST YOU, CALL TOLL FREE 1-888-992-4657 (U.S.A. AND CANADA ONLY). FOR LOCAL CALLS,
SEE LISTING BELOW.
U.S./Canada Sales and Customer Service Office Address Telephone No.
Glendale Heights, IL 60139 195 Internationale Blvd. (630) 237-5000
Toll Free Fax No. 1-877-790-6965
AUTOMOTIVE FINISHING
Binks has authorized distributors throughout the world. For equipment, parts and service, check the
Yellow Pages under “Automotive Body Shop Equipment and Supplies”. FOR TECHNICAL ASSISTANCE,
CALL TOLL FREE 1-800-445-3988 (U.S.A. ONLY). FOR LOCAL CALLS, SEE LISTING BELOW.
U.S. Customer Service Office Address Telephone No.
Maumee, OH 43537 1724 Indian Wood Circle (419) 891-8100
Toll Free Fax No. 1-800-445-6643
2463R-9 Revisions: (P2) Revised art; (P4) Added footnotes to Item Nos. 21 and 22, added
Item No. 37; (P5) Updated Fluid Nozzle charts; (P8) Deleted Part No. 54-3902 from the
Air Nozzle Test Gauge Assembly chart.
To Previous Page
Loading...
