Binks SV100 Conventional
Suction Feed Spray Gun
The following instructions provide the necessary
information for the proper maintenance of the Binks
SV100 suction feed spray gun. Please read and understand
all the information in this document in order to get the
maximum performance from your new SV100 suction
spray gun.
The SV100 spray gun is the result of quality engineering
and development activity. The result is an ergonomic
product with reduced triggering effort and fine atomization.
The specification table details the operating parameters of
the gun. In addition, the relatively low air flow rate of the
SV100 spray gun will help in containing overspray.
The SV100 spray gun should be operated under the safety
directions outlined in this literature. Your safety and the
safety of others depend on your thorough understanding
of the material contained on the Part Sheet.
If you have any questions or do not understand the
content in this literature, call your nearest service
representative.
Replaces
Part Sheet
77-2876
Part
Sheet
77-2876R
SPECIFICATIONS
Max. Air Pressure: 175psi/12bar
Gun Body: Cast Aluminum
Fluid Path: Stainless Steel
Fluid Nozzle: Stainless Steel
Fluid Needle: Stainless Steel
Fluid Inlet Size: 3/8" NPS(M)
Air Inlet Size; 1/4" NPS(M)
Gun Weight: 1.17 lbs. (532 g)
SV100-630K @30 psi 8 cfm
Air Consumption: @50 psi 11 cfm
To Next Page
Need help?
General
