EN
77-2874-R7.5 (6/2016) 1 / 8
SERVICE MANUAL
BINKS SV100™ HVLP
PRESSURE FEED SPRAY GUN
7041-6931-1
SPECIFICATIONS
Max. Air Pressure: 175psi/12bar
For HVLP Compliance: 26 psi inlet pressure delivers
(with SV100-693K cap) 10 psi air cap pressures at
12 cfm air volume
For HVLP Compliance: 20 psi inlet pressure delivers
(with SV100-690K cap) 10 psi air cap pressures at
6.5 cfm air volume
Gun Body: Cast Aluminum
Fluid Path: Stainless Steel
Fluid Nozzle: Stainless Steel
Fluid Needle: Stainless Steel
Fluid Inlet Size: 3/8" NPS(M)
Air Inlet Size; 1/4" NPS(M)
Gun Weight: 1.12 lbs. (507 g)
The following instructions provide the necessary information
for the proper maintenance of the Binks SV100 pressure feed
spray gun. Please read and understand all the information in this
document in order to get the maximum performance from your
new SV100 pressure spray gun.
The SV100 spray gun is the result of quality engineering and
development activity. The result is an ergonomic product with
reduced triggering effort and fine atomization. The HVLP air
cap has been specifically designed to comply with local
regulatory air quality restrictions. The specification table details
the operating parameters of the gun to achieve those compliant
conditions. In addition, the relatively low air flow rate of the
SV100 spray gun will help in containing overspray.
The SV100 spray gun should be operated under the safety
directions outlined in this literature. Your safety and the safety
of others depend on your thorough understanding of the
material contained on the Part Sheet.
If you have any questions or do not understand the content in
this literature, call your nearest service representative.
To Next Page
Need help?
General
