Binks SV100 - Spraying Techniques and Troubleshooting; Optimal Spraying Technique; General Spraying Instructions; Fan Spray Control

EN
77-2874-R7.5 (6/2016) 5 / 8
BINKS SV100
™
HVLP PRESSURE FEED SPRAY GUN
ITEM PART
NO. NO. DESCRIPTION QTY.
1 SV100-693K AIR CAP .............................................. 1
1a SV100-690K AIR CAP (not shown) ......................... 1
2★ — FLUID TIP 1.1 mm ............................... 1
2a★ — FLUID TIP 1.4 mm (not shown) .......... 1
2b• — FLUID TIP 1.8 mm (not shown) .......... 1
3★■ — GASKET ............................................... 1
4k — BAFFLE ................................................ 1
5★■ •t — GASKET ............................................... 1
6★■ •t — PACKING ............................................. 1
8 — GUN BODY ......................................... 1
9k — SPRAY PATTERN VALVE ..................... 1
10■ — U-CUP SEAL ........................................ 2
11■ — AIR VALVE SEAT ................................. 1
12 — AIR VALVE STEM ................................ 1
13 ■ — AIR VALVE SPRING ............................. 1
14 — AIR VALVE BUSHING .......................... 1
15★ — FLUID NEEDLE 1.1 mm ....................... 1
15a★ — FLUID NEEDLE 1.4 mm (not shown) .. 1
15b• — FLUID NEEDLE 1.8 mm (not shown) .. 1
16★• — FLUID NEEDLE SPRING ....................... 1
17 — FLUID ADJUSTMENT KNOB ............... 1
ITEM PART
NO. NO. DESCRIPTION QTY.
18 — NIPPLE ................................................. 1
19 SGK-457 AIR ADJUSTING VALVE ASSEMBLY ... 1
20 — FLUID NIPPLE ...................................... 1
21 — WASHER ............................................. 1
22 — NUT ..................................................... 1
23 — FLUID NIPPLE ASSEMBLY ................... 1
24 — TRIGGER PIN ASSEMBLY .................... 1
25 — TRIGGER ............................................. 1
26 ■ — ASSEMBLY TOOL ................................ 1
★ K-5052 Pressure Gun Fluid Tip and Needle Replacement Kit
(includes 1.1 and 1.4 mm tips & needles)
• K-5052-18 Pressure Gun Fluid Tip and Needle Replacement Kit
(1.8 mm)
k SGK-454-K Spray Pattern Valve and Baffle
■ K-5057 Soft Parts Kit
t SGK-537-K 5 ea. Packings and Baffle Gasket
NOTE: Use 1.1 mm fluid tip/needle with low viscosity materials.
Use 1.4 mm fluid tip/needle with high viscosity materials.
PARTS LIST
(When ordering, please specify Part No.)
TEST AIR CAP KITS
(sold separately)
54-5654 SV100-693
54-5657 SV100-690