77-2946
page 3
Warning
HIGH PRESSURE CAN CAUSE SERIOUS INJURY IF EQUIPMENT IS INSTALLED OR USED
INCORRECTLY— READ, UNDERSTAND, AND OBSERVE ALL WARNINGS AND INSTRUCTIONS IN
THIS MANUAL.
INSTALL, OPERATE OR SERVICE THIS EQUIPMENT ONLY AFTER ALL INSTRUCTIONS
ARE CLEARLY UNDERSTOOD.
It is the responsibility of the employer to place this information into the hands of the operator.
NOTE
Important installation, operation or
maintenance information.
CAUTION
Hazards or unsafe practices which
could result in minor personal injury,
product or personal damage.
WARNING
Hazards or unsafe practices which
could result in severe personal injury,
death or substantial property damage.
AVOID STATIC SPARKING
1. Use Binks NO-WIRE conductive hose in
all airless spraying operations. Be sure
the gun and hose have continuity.
2. Make sure the pump is grounded.
NEVER operate the unit when it is on a
non-grounded platform.
3. When flushing or cleaning with a
combustible solvent, always use an
open metallic container for receiving
the waste solvent. Ground the solvent
receptacle.
4. ALWAYS remove spray tip when
flushing the system. Operate the pump
at the lowest possible pressure.
GENERAL WARNINGS
1. NEVER leave a pressurized sprayer
unattended.
2. Periodically inspect all hoses for leaks
and/or abrasions and tighten all
connections before use. DO NOT
ATTEMPT TO REPAIR a defective hose.
REPLACE it with another conductive
hose.
3. ALWAYS relieve pressure in the system
by turning bypass valve to BYPASS or
triggering spray gun before disassembly
of any component parts.
REPLACEMENT PARTS
The pump is designed to use authorized
parts only. When using this pump with
parts that do not comply with the
minimum specifications and safety
devices of Binks, the user assumes all
risks and liabilities.
CAUTION
Never store de-ionised, distilled,
reverse osmosis or and pure grades of
water in the pump. These fluids may
cause corrosion.
NOTE
BINKS is not responsible for
misapplication of pumps. Consult your
BINKS representative for application
assistance
WARNING
EXCESSIVE AIR PRESSURE
Can cause personal injury, pump
damage or property damage. Do not
exceed maximum inlet air pressure as
stated on motor plate.
NOTE
Be sure that all fluids, solvents and
fillers to be used are chemically and
physically compatible with wetted
parts in the pump. Consult your BINKS
representative for pump materials of
constructions and compatibility infor-
mation. Consult the fluid manufacture
for information regarding the fluids to
be used.
To Next Page
Loading...
