Option 2 - Reset with the charging cable
1. Connect the transmitter to a powered USB wall charger through the
supplied USB cable.
2. Quickly unplug it from the cable.
3. Repeat this action three times or until you see a blinking red light.
4. Switch the smartdot™ transmitter on by plugging it until you see the
blue light of charging and then unplug the USB cable. See steps C-E
in ‘Part 5: Preparing’.
x3
If the red light remains, your transmitter is still defective. Remove it
from your injection pen and contact your healthcare professional for
further assistance.
Note: You can still perform your injections without using your
transmitter.
Part 9: Troubleshooting guide
22
To Next Page