17 Biodex Medical Systems, Inc. © 2018
Installing Kick Plates
For instructions on installing the kick plates, refer to the Lead-Lined Laboratory Furniture
Manual on www.biodex.com/nuclear-medicine/products/shielding-storage/lead-lined-
laboratory-furniture.
Maintenance
As required, wipe all surfaces except the Dose Calibrator with a clean cloth and a solution of
warm water with a mild detergent (or Radiacwash for decontamination).
Wipe the Dose Calibrator with a soft cloth dampened with alcohol.
Disposal
An appropriate waste disposal company is to be contacted (i.e., the local collection point for
waste separation). Properly dispose of the device at the end of its service life:
The device packaging is disposed of through resource recycling.
The metal parts of the machine go to scrap metal disposal.
Plastic parts are disposed of as hazardous waste.
The disposal of equipment must be in accordance with the respective
national regulations.
Wear parts are considered hazardous waste! After being replaced, wear
parts must be disposed of according to country-specific waste laws.
To Next Page
Loading...