Biohit eLine - Intended Use; BIOHIT E LINE CHARGING STAND; Installing the Charging Stand;Carousel

2
1. INTENDED USE
This liquid handling device is designed and manufactured to be used with
the IVD-product as an IVD-accessory and as a stand alone laboratory
equipment.
2. BIOHIT eLINE CHARGING STAND
The Biohit eLINE Charging Stand and Carousel are bench top charging
units. The Stand accommodates one Biohit eLINE pipette and the Carousel
four Biohit eLINE pipettes.
Cat. No Product
73098(X) Biohit eLINE Charging Stand
73099(X) Biohit
eLINE Charging Carousel
X: 0 = Without adaptor; 1 = With universal AC-adaptor (Euro, USA/Jpn, UK
and China plugs)
3. INSTALLING THE CHARGING STAND/CAROUSEL
1. Carousel: Connect the four place charging head by pressing it into the
stand base connector. Test for free rotation (Fig. 1A).
2. Carousel and Stand: Connect the AC-adaptor to the socket at the rear
of the Charging Stand/Carousel (Fig. 1B and Fig. 1C).
3. Carousel and Stand: Connect the AC-adaptor to the electrical outlet
(Fig. 1B and Fig 1C).
Note: Before connecting the AC-adaptor to the electrical outlet, check that
its voltage settings corresponds to the voltage settings of your electrical
outlet.
Fig.1A Fig.1CFig.1B