1918
Meter Activation and Battery Change
Your RIGHTEST Max Blood Glucose Meter comes with one CR2032, 3 volt, battery installed. One
new battery will provide power to perform approximately 1000 tests under normal use. Press the
main button or insert a strip to activate your meter.
Meter Activation and Battery Change
CAUTION
- Please follow the local regulation to properly discard a used battery.
4. RIGHTEST Blood Glucose Meter will enter Self-Testing Mode automatically when replacing the
battery (all symbols will appear on the screen).
5. Press any button to exit the self-test and enter Setting Mode.
6. You must set the time and date when replacing the battery. See Chapter " Setting Up Your Meter -
Setting the Date, Time, and Volume " on page 20. Test results are still stored in the memory.
2. Install the battery into the
chamber with electrode.
Be sure to put the battery
in the correct direction
(polarity (+)facing up).
1. Use a pen point to press the
bottom-right spot on the cover, at
the same time slide up the cover.
3. Slide the battery cover
back until it snaps into
place.
To Next Page
Loading...
