Project Type
Instructions
Date: March 27 2020
Customer: Thermor Ltd
Job Number: TH1011
Item Number: 3AL1-3E
Designer: Alex Vranjesevic
Revision: B
Artwork is not to be amended or scaled. If any changes
are required please send through Thermor oce with
instructions, and we will amend here and resend artwork
through. PLEASE RETURN WITH SIGNATURE
Contact: Graphic’s Department
graphics@thermor-ins.com
Colour Breakdown
Reason For Project:
New Item:
New Branding: X
Design Update:
N/A:
UPC (For Reference Only)
2. Next, the screen starts flashing the month and date setting. Press the button
repeatedly to set the month and date, and then press the button to confirm the
settings.
3. Lastly, the screen starts flashing the hour and minute values. Press the button
repeatedly to set the hour and minutes and then press the button to confirm the
settings.
3.2 Select the User
This blood pressure monitor is designed to store 99 measurements for each of two users.
Before taking a measurement, be certain that the correct user has been selected.
a) Press and hold the
button for 3 seconds until the user icon in the upper left corner of
the LCD screen flashes.
b) Press the button to toggle between users.
c) Press the button again to confirm your selection. You will need to press the icon to
cycle through each time and date settings until you are back in default mode.
3.3 Obtaining Accurate Measurements
Your blood pressure can vary based on numerous factors, physiological conditions, and your surroundings. Follow
these guidelines to obtain accurate and error-free measurements of your blood pressure and pulse rate.
3.3A Tips on Taking Accurate Measurements
In the morning before breakfast,
2 hours after dinner, before taking
medication.
Avoid coffee and smoking within the
hour, and no exercise 30 minutes
before measuring.
Do not speak while taking the
measurement.
Sit with legs uncrossed so as not to
restrict blood flow.
Empty bladder (if necessary).
Rest quietly for 5 minutes. Remain
calm and quiet while the measurement
is in process.
Take measurements on the non
dominant arm.
Sit with back supported and
measurement arm resting on a table.
Sit with feet flat on the floor.
Ensure that the cuff is level
with the heart while the arm is
supported on the table.
3.3B Common Sources of Error
All efforts by the patient to support the arm can increase the blood pressure. Make sure you are in a comfortable,
relaxed position and do not activate any of the muscles in the measurement arm during the measurement. Use a
cushion for support if necessary.
To Next Page
Loading...
