Motherboard Manual
20
6. Select the proper BIOS file, and a
message asking if you are sure to
flash the BIOS file. Click Yes to start
updating BIOS.
7. A dialog pops out after BIOS flash is
completed, asking you to restart the
system. Press the [Y] key to restart
system.
8. While the system boots up and the full screen logo shows up, press
<Delete> key to enter BIOS setup.
After entering the BIOS setup, please go to the Save & Exit, using the Restore
Defaults function to load Optimized Defaults, and select Save Changes and
Reset to restart the computer. Then, the BIOS Update is completed.
To Next Page
Loading...
