7
NEVER REACH OR GRAB FOR PRODUCT IN FRONT OF
MOVING BAND TYPE SAW BLADE
2. Make sure all doors are closed and locked.
5. Standing in front of the power saw, place product on the meat carriage. Pay attention to position of your
hands. Keep hands clear of moving band type saw blade. Leaning lightly against the scalloped front edge
of meat carriage, hold the product rmly in right hand with product face ush against the meat gauge
plate. Move the meat carriage from right to left at a steady rate until fully past the saw blade. Use left
hand to remove and stack cut product, NEVER REACH IN FRONT OF BAND TYPE SAW BLADE.
On the return stroke, pull the product slightly toward you, away from the saw blade.
3. Adjust meat gauge plate forward to desired thickness of cut. “A”
4. Push start button and watch blade for proper tracking.
6. ALWAYS use the Safety End Cut Pusher Plate (Part No. 256P) for smaller products or the last cuts of
product. “C” The pusher plate is supplied as standard on all BIRO power saws.
7. When nished cutting, push stop button. Perform lockout/tagout procedure.
To Next Page
Loading...
