6
OPERATION
SHARP MOVING BAND TYPE SAW BLADE
TO AVOID SERIOUS PERSONAL INJURY
ONLY Properly Trained Personnel Should Use This Equipment.
ALWAYS Keep Hands Clear of Band Type Saw Blade and Other Moving Parts.
DO NOT Tamper With, Bypass, Alter, or Modify this Equipment in Any Way or Form.
NEVER Operate with Saw Guard on Saw Guide Bar in the Raised Position or the Saw Guard
Removed from the Saw Guide Bar.
ALWAYS Adjust the Saw Guide Bar with Saw Guard to Within ½” of Product to be Cut.
ALWAYS Use Safety End Cut Pusher Plate for Smaller Products or The Last Cuts of Product.
DO NOT Wear Gloves While Operating.
ALWAYS Turn Off, Unplug from Power Source and Perform Lockout/Tag Out Procedures Before
Cleaning, Servicing or When Not in Use.
NEVER Leave Machine Unattended While the Saw is Running.
NEVER Operate Without All Warning Labels Properly Afxed to Machine.
A. TO PROCESS PRODUCT
1. Before starting power saw, adjust saw guide bar with saw guard to within ½”(13 mm) of product to
be cut.
DO NOT WEAR GLOVES WHILE OPERATING
E
R
G
N
A
D
To Next Page
Loading...
