BIRO 3334SS - Installation

INSTALLATION
1. Read this Manual thoroughly before installation and operation. Do not proceed with installation and
operation if you have any questions or do not understand anything in this Manual. Contact your local
Distributor, or BIRO rst.
3
3. After installing machine in operational area, it is imperative that the four adjusting legs be adjusted to
level the machine.
4. To assemble the meat gauge plate (Part No. AS16275) to the machine, loosen the lock knob
(Part No. 272-7-1) on the right side of meat gauge bracket. Raise the meat gauge gear rack (Part No. S16272)
and slip the meat gauge plate over the gear rack. Lower the gear rack to its original position, tighten lock
knob. Keep gear rack well oiled with a food grade oil to ensure free movement.
ALWAYS LEVEL MACHINE BEFORE USING
USE ONLY BIRO Parts and Accessories Properly Installed.
ALWAYS Read Operating and Service Manual BEFORE Operating, Servicing, or Cleaning.
ALWAYS Use Qualied Technician and Electrician for Installation.
ONLY Install on a Level, Non-Skid Surface in a Clean, Well-Lighted Work area Away From Children and
Visitors.
NEVER Operate Without all Warning Labels Attached and Wall Chart Posted.
NEVER Operate with Saw Guard Bar with Saw Guard in the Raised Position or the Saw Guard Removed from
the Saw Guide Bar.
DO NOT Attempt to Operate This Machine Until it has Been Inspected and Demonstrated by the Seller -
Recognized BIRO Representative.
DO NOT Alter or Modify This Machine in Any Way from its Original Form. This Machine in its Original
Form Meets the Intent of O.S.H.A Applicable Standards.
TO AVOID SERIOUS PERSONAL INJURY
PROPERLY INSTALL EQUIPMENT IN ADEQUATE WORK AREA
ALWAYS Turn Off, Unplug From Power Source and Perform Lockout/Tagout Procedure to This Machine
BEFORE Removing Shrouds, Removable Guards, Covers, Doors, Fences or Panels for Cleaning,
Servicing or Any Other Reason.
NEVER Leave Machine Unattended While the Saw is Running.
5. The head structure (Part No. 16005) comes detached from the
base. Slip the head into the slide gibs (Part No. 260) located on
the back of the base structure. Make sure the slide gibs are oiled
or greased to ensure free vertical movement of the head structure.
2. Install machine on a level, solid, non-skid surface in a well-lighted work area away from children and
visitors.