Bissell PET STAIN ERASER 3182 Series User Manual (English)

Questions and Answers:

V
Vanessa YoungAug 9, 2025
Why is there reduced or no spray from my Bissell Ultrasonic Jewelry Cleaner?
- R
  Robert JohnsonAug 9, 2025
  If your Bissell Ultrasonic Jewelry Cleaner isn't producing spray or the spray is weak, there are a few things to check: 1. **Priming the pump:** With the machine on, press and hold the spray trigger for a few seconds to prime the pump. 2. **Clogged nozzle:** Clear any blockages from the spray nozzle using a paper clip. 3. **Incorrect position:** Ensure you are using the machine in a horizontal position.
G
Gary MooreAug 15, 2025
How to fix Bissell Ultrasonic Jewelry Cleaner that is not powering ON?
- J
  Jonathon KellyAug 15, 2025
  If your Bissell Ultrasonic Jewelry Cleaner isn't powering on, the most likely reason is that the battery is depleted. Make sure to fully charge the machine before using it.
S
Shannon PerezAug 21, 2025
What to do if Bissell PET STAIN ERASER 3182 is leaking?
- M
  Melissa BradfordAug 21, 2025
  If your Bissell Ultrasonic Jewelry Cleaner is leaking, consider the following possible causes and solutions: 1. **Dirty gasket:** A dirty water tank plug gasket can cause leaks. Clean the gasket thoroughly. 2. **Improper installation:** The dirty water tank and plug may not be correctly installed. Remove and reinstall them, ensuring they are secured in place. 3. **Full tank:** If the dirty water tank is full, empty it promptly. Also, avoid storing the machine on its side. 4. **Incorrect positioning:** Ensure the machine is in a horizontal or upright position, not tilted on its side, back, or pointed downward.
M
Michelle NicholsAug 28, 2025
Why is my Bissell PET STAIN ERASER 3182 not charging?
- T
  Teresa HillAug 28, 2025
  If your Bissell Ultrasonic Jewelry Cleaner isn't charging, ensure that the charger plug and cord are properly connected. Make sure the charger cord is securely inserted into the machine and the charger plug is fully inserted into a working wall outlet.
D
deannakingSep 2, 2025
What to do if my Bissell PET STAIN ERASER 3182 Ultrasonic Jewelry Cleaner has no suction?
- J
  Jacob McintoshSep 3, 2025
  If your Bissell Ultrasonic Jewelry Cleaner has reduced or no suction, here are a few things to check: 1. **Tank installation:** Ensure the dirty water tank is properly installed and the plug is secure. 2. **Suction lens:** Remove, clean, and reinstall the suction lens, as it may be clogged or improperly installed. 3. **Lens engagement:** Tilt the machine forward and press down firmly on the carpet to ensure the suction lens engages properly. 4. **Filter debris:** Remove any debris from the red filter located behind the dirty tank assembly.