www.bissell.com 800.237.7691
11
Maintenance and care
Clearing a clog
Low suction or poor pickup may be
due to a clog in the vacuum. If you
notice a change in the sound of the
vacuum motor, check for clogs.
1. Turn power OFF. Unplug vacuum cord
from electrical outlet.
2. Empty dirt container.
3. Check upper tank and suction inlet for clogs.
4. Grasp Quick Reach Handle and remove
hose wand from base to check for clogs
in the base, the wand, and the hose.
5. Remove the screw attaching the hose
wand base to the vacuum. Straighten the
hose wand base and unclog with long,
narrow object such as broom stick.
6. If the clog persists, follow steps for checking
rotating floor brush on page 10 and inspect
the air passageway for obstructions.
3.
Suction inlet
5.
Remove
Screw
To Next Page
Loading...
