5.1 Handle adjustment 08
5.2 Seat cushion 09
5.3 Canopy and Canopy bracket 09
5.4 Baby fixation and notes 10-13
5.4.1
Y-shaped belt adjustment 10-11
5.4.2 Baby fixation 12-13
5.5 Installation in vehicle 13-15
5.6 Check the belt and make sure its route goes on correctly 15
6 Maintenance 16-24
6.1 Attention 16
6.2 Cover cleaning 16
6.3 Remove the canopy and cover 17-21
6.4 Installation of canopy and cover 22-24
7 Warranty condition and warranty card 25-26
Certification
●This baby safety seat is designed and tested with the European
Children Ristraint System standard (ECE R44/04) and the Chinese
Children Ristraint System standard (GB27887-2011). The certification
stamp E mark (in the round circle) with approval number and the
CCC mark (in the ellipse circle) can be found on the labels (in the
bottom side of this seat)
●Any modification of this seat by you will lead to invalidity of the
certification. Nobody is authorized to modify baby safety seat unless
the baby safety seat manufacturer.
1.Application scope
Certificated by ECE R44/04 and GB27887-2011, this baby safety
seat is applicable for Group 0+ infants.
BIUCO Baby safety seat
BC100B
Group
0+
Range of baby weight
0-13kg
2.Important notes
To protect the baby
●Important!Due to problem at birth, some baby might be
underweight, please confirm with the doctor before using this seat.
●Important!Do not use any accessory which is not shown in this
instruction.
●Important!Do not fix this seat in ways that are not shown in this
instruction.
●Do not leave your baby alone in this baby safety seat in your car.
●Do not remove the labels , important information contained.
●Do not modify this seat in any form.
●Do not disassemble this seat unless following the instruction.
BC100B User Instruction
●Do not use borken or abrasive baby safety seats or seat belts.
●Do not use a post-accident baby safety seat. Invisible damage
might be made to the baby safety seat after crash.
●Check the baby safety seat and belts to make sure every part
functions well.
●No twine or twisting of the belts.
●Fasten the baby safety seat’s 3-point belt when baby inside.
●Every time using this seat, make sure its handle is locked
in“ carrier position”.
●Empyrosis possibility！Cover this seat when the car is exposed in
sunshine. The safety seat parts might be overheated and burn your
baby’s skin. Check the temperature before using the seat.Sunshine
can also lead to a cover fading.
●Rear-facing installation of this seat ONLY.
●Do not place the seat near edges of high, uneven or soft-surface
places. The seat may fall from there and your baby may get hurt.
●Do not use the product in seating positions where an active frontal
airbag is installed.
●Do not use any load bearing contact points other than those
described in the instructions and marked in the child restraint.
To Next Page
Loading...