3-2-4-2 Charging Battery (Printer)
1) Insert the battery into the Quad
charger as shown in the figure on
the left.
2) Gently slide the battery until it
reaches the bottom of the charger.
3) Charging starts as soon as the
battery is completely inserted.
4) After charging, remove the battery
from the Quad charger.
NOTE
Battery charging status descriptions are as follows.
Error Replace
or Reinstall Battery
CAUTION
1. If the red lamp of the charger blinks, install the battery again.
2. If the red lamp continues to blink despite several attempts (4 ~ 5 times) to install the
battery, contact your local dealer.
3. The charging time may vary depending on the type of the charger or ambient
temperature.
To Next Page
Loading...
Need help?
General
