BIXOLON SRP-270 Command Manual

Rev. 1.01
- 8 -
SRP-270
n = 3 : Error status
Bit Off/On Hex Decimal Function
0 Off 00 0 Not used. Fixed to Off.
1 On 02 2 Not used. Fixed to On.
2 Off 00 0 No mechanical error.
On 04 4 Mechanical error occurred.
3 - - - Undefined.
4 On 10 16 Not used. Fixed to On.
6 Off 00 0 No auto-recoverable error.
On 40 64 Auto-recoverable error has occurred.
7 Off 00 0 Not used. Fixed to Off.
Bit 2 :
Bits 2 & 3 :
Bit 6 :
Mechanical errors include home position, carriage sensor, and slip ejection
errors.
If these errors occur due to paper jams or the like, it is possible to recover by
correcting the cause of the error and executing ELE ENQ n(1 ≤n ≤2). If an
error due to a circuit failure (e.g. broken wire) occurs, it is impossible to
recover.
If the print head temperature becomes high, bit 6 is transmitted until the print
head temperature drops sufficiently. The printer automatically recovers from
this error.
n = 4 : Continuous paper sensor status
Bit Off/On Hex Decimal Function
0 Off 00 0 Not used. Fixed to Off.
1 On 02 2 Not used. Fixed to On.
Off 00 0 Paper roll end sensor. Paper adequate. 2
On 04 4 Paper roll end sensor. Paper end.
Off 00 0 Paper roll end sensor. Paper adequate. 3
On 08 8 Paper roll end sensor. Paper end.
4 On 10 16 Not used. Fixed to On.
Off 00 0 Paper roll end sensor. Paper present. 5
On 20 32 Paper roll end sensor. No paper.
On 00 0 Paper roll end sensor. Paper present. 6
On 40 64 Paper roll end sensor. No paper.
7 Off 00 0 Not used. Fixed to Off.
DLE ENQ n
[Name]
[Format]
[Range]
[Description]
Real-time request to printer.
ASCII DLE ENQ n
Hex 10 05 n
Decimal 16 5 n
1 ≤n ≤2
Recovers from an error after clearing the receive and print buffers.
This command is available only with a serial interface, and is ignored with
a parallel interface.

BIXOLON SRP-270 Specifications

General

Color	No
Maximum print size	-
Media thickness	76 mm
Print technology	Dot matrix
Power requirements	120-230VAC
Standard interfaces	Parallel, Serial