Network Connection Manual
Ver.1.00
1. Introduction
This Network manual provides information on the connection of network with the
Industrial Label printer.
2. Precaution
1) The printer has to be within 100m(Outdoor) from AP(Access point) to connect
WLAN. Although 35m is able to communicate in door, WLAN could be affected by
environment to be shorten.
2) The maximum separating distance may be shortened if transmission obstacles,
such as cement walls, are present.
3) If a device (such as a microwave oven, wireless LAN, etc.) that uses the same
frequency is present, transmission may be interrupted. Separate the printer and
Bluetooth-enabled device from such interrupting devices by a distance of at least 5m.
To Next Page
Loading...
Need help?
General