BIXOLON SRP352III - Specifications

Rev. 1.03
- 23 -
SRP-350/352III
4. Specifications
Printing Method
Thermal transfer printing
Dot Density
SRP-350III: 180 dpi (7dots/mm)
SRP-352III: 203 dpi (8dots/mm)
Printing Width
3 inches
72 mm
2 inches
48 mm
Roll Width
3 inches
79.5±0.5 mm
2 inches
57.5±0.5 mm
No. of Characters per Line (Default Value)
SRP-350III
: 42 (Font A) ,56 (Font B), 56 (Font C)
SRP-352III
: 48 (Font A) ,64 (Font B), 64 (Font C)
Printing Speed
Max. 250 mm/sec
Receiving Buffer Size
4K bytes
※ CAUTION
Printing speed may be slightly slow depending on the data transmission speed and the
combination of commands.
Supply Voltage
SMPS Input Voltage
100~240 VAC
Frequency
50/60 Hz
SMPS Output Voltage
24 VDC
Environment Condition
Temperature
Operating: 0 ~ 45 ℃
Storage: -20 ~ 60 ℃
Humidity
Operating: 10 ~ 80 % RH
Storage: 10 ~ 90 % RH
Paper excluded
Life Span
Mechanism Header *)
150 Km
Auto Cutter
1,800,000 cuts
MCBF
Mechanism *)
70,000,000 lines
*) The specifications were determined based on operation at normal temperature using
designated paper on default settings. They are subject to change depending on
temperature or printing level.
*) The specifications were tested according to standard reliability. If you want to test the
product to determine its life cycle, please contact us for more details and comply with the
standard reliability for testing.
* These values may vary with environment temperature, printing level, etc.
* The switch is the disconnecting device. Turn off switch from any hazard.