Bizerba VS 12 D-V User Manual

5.3 Cleaning plan VS 12 D–V (the operating instructions should be observed)
CLEANING
6.083.98.5.14.00
(1) Steps Cleaning agents Procedure Cleaning equipment Hints and tips
1 Preparatory measures
Set slice thickness below zero
Switch off machine
Disconnect power plug
2
Dismantling
of removable parts
According to the operating
instructions
3
Rough cleaning
Manual removal of product
residue
Plastic scraper
Plastic spatula
Brush
Must be done immediately
after use. This applies
equally to the removed
parts.
4 Cleaning
2%
P3–steril
Pre–rinsing with water at
max. 50
° C in relation to the
grease fusion point
Manual
Induction period of
approximately 15 minutes
Brush
Tub
Disposable cleaning cloth
Hand sprayer

Dish washing machine 
All removed and fixed
machine parts
* See notes
Removed parts
4.1
Sanitizing
Additional measures
0,5 – 2%
P3–alcodes
Use concentrate undiluted
Manual
Spraying
Induction period according
to product data sheet
Disposable cleaning cloth
Hand sprayer

Additional precautionary
measure: spray at a
distance of 0,30 m.
Recommended quantity to
be used: 40–50 ml/m2
* See notes
4.2
Acidic cleaning
Additional measures
max. 3%
P3–riksan
Manual/mechanical
Foaming
Induction period of
approximately 15 minutes
Brush to remove calcareous
deposits
Hand sprayer

Only in case of need
Calcareous deposits must
be rinsed away immediately
after cleaning.
* See notes
38

Bizerba VS 12 D-V Specifications

General

Type	Slicer
Model	VS 12 D-V
Brand	Bizerba
Blade Diameter	300 mm
Slice Thickness	0 - 24 mm