1.1 Warranty
GENERAL
6.083.98.5.14.00
Contact us or your local after–sales service, if
any information is not properly understood.
Equipment should only be transported and
stored in its original packing.
Equipment should not be started up before
the requirements of the Bizerba operating
conditions are met.
The supporting area should be horizontal,
level, stable and non–slippery. Equipment
should be arranged in such a way as to
facilitate operation, working procedures
and service.
Initial installation, commissioning,
introduction, cleaning, maintenance and
servicing should only be carried out by the
relevant BIZERBA after–sales service or
by companies or personnel authorized by
BIZERBA.
The use of hardware and software which
may be necessary for a data dialog
between BIZERBA and non–BIZERBA
equipment is subject to written approval
from BIZERBA.
Equipment should not be set into operation
before supervisory and operating
personnel have thoroughly read and
understood these operating instructions.
Only trained personnel should operate the
equipment. Training should be repeated.
BIZERBA does not accept liability for
damage arising as a result of installation by
anyone other than
BIZERBA–incorporated or designated
representatives, faulty electrical
connection by the user, improper
operation, inappropriate use, modification
of equipment in any way from its original
form, removal of guards, the use of spare
parts and accessories other than genuine
BIZERBA parts or accessories.
The user will be responsible for any
damage or injury arising as a result of
failure to observe the BIZERBA
instructions.
Therefore, it is strongly recommended to
use only genuine BIZERBA spare parts
and accessories.
Normal wear and tear are not covered by
the guarantee.
To provide operational assurance
and to protect personnel from
possible injuries, the requirements
of these instructions must be met
before the machine is set into
operation and during operation.
These instructions are subject to revision as
further product development, experience and
investigation may show is necessary or
desirable. Graphics appearing in these
instructions may differ slightly from the model
supplied due to country–specific regulations.
This does not affect the contents of these
operating instructions.
4
To Next Page
Loading...
Need help?
General
