BJ-256 BJ Control Pro
User Guide
NOTE: Sometimes, when the switch is connected to the remote via the control
input, the LEDs of the different cells begin to light up in sequence. This is not a
malfunction. Once the LED of every cell has lit up, the remote will go into standby
mode, ready for use.
NOTE: Full scanning is performed just once any time you press the switch. To
repeat it, press the switch again.
5 Configuring the remote
We recommend configuring the remote to suit your needs when you use it in
"sequential control" mode. Configuring the remote correctly will ensure more
efficient and convenient access and control. This section describes the various
parameters that can be configured. Section 7 of this manual describes how you can
modify any of these parameters.
The parameters that can be configured are:
Scan time
Indicates the time elapsed between one cell lighting up and the next, or between
one row and the next. Values from 0.1 to 9.9 seconds can be entered. The values
must be entered in the format “x.y” [seconds][.] [tenths of a second].
Scan mode
You can choose between the two types of scan described in the previous section:
cell-to-cell scanning and scanning by rows and columns. The codes to enter are 000
(simple scanning) or 001 (scanning by rows/columns).
First scan option extra time
Extra time needed for the user to activate the switch a second time in order to
activate the first cell. Values from 0.1 to 9.9 seconds can be entered. The values
must be entered in the format “x.y” [seconds][.] [tenths of a second].
Accidental press time
Refers to the time after the switch is pressed during which the remote ignores
subsequent presses. For example, if a time is set of 0.5 seconds after the switch is
pressed, the remote will ignore further presses until this time has elapsed.
Increase this value if the switch may be unintentionally activated repeatedly just
after it has been intentionally activated.
The values must be entered in the format “x.y” [seconds][.] [tenths of a second].
Levels
This determines the maximum number of levels you wish to have available on the
remote both for scanning and for use as a direct control, up to a maximum of eight.
Codes 001, 002, 003, 004, 005 and so on should be entered.
To Next Page
Loading...