EasyManuals Logo

Black & Decker 10BLE-025 User Manual

Black & Decker 10BLE-025
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
15
PROBLEM POSSIBLE CAUSE CORRECTION
Motor will not start or stops while
operating.
Defective GFCI. Perform GFCI reset procedure. See Operator’s
Manual page 6.
Extension cord length or gauge incorrect. Use proper extension cord. See Operator’s
Manual page 6.
Loose or disconnected plug. Reconnect plug.
Tripped pressure washer thermal switch. Allow to cool and restart unit.
Spray Gun Trigger not operating
properly.
Call Customer Service.
Defective gun. Remove gun, aim water stream away from
electrical source, and press ON. If machine
starts, replace gun assembly by contacting
Customer Service.
Circuit breaker trips or fuse
blown in fuse box.
Circuit overload. Check that the circuit is rated 15 amps or
greater.
Extension cord too long or wire size too
small.
Use proper extension cord as recommended on
Operator’s Manual page 6.
Nozzle partially blocked. Clean nozzle as instructed on page 14.
Excessive pressure. Clean nozzle as instructed on page 14.
Water or oil leaking from bottom
of pump.
A small amount of leakage is normal. If excessive leaking occurs, call Customer
Service.
Trigger will not move. Spray gun safety lock engaged. Release safety lock.
Unit will not stop when trigger is
released.
Spray gun trigger system not operating
properly.
Call Customer Service.
Motor running but pump not
building maximum pressure or
has irregular pressure.
Faucet closed. Open faucet.
Water inlet screen clogged. Clean screen. See page 14.
Gun and hose failure. Replace gun and hose.
Kink in garden hose. Straighten hose.
Nozzle worn out. Replace spray nozzle.
Air in pump. Let pressure washer run with gun open and
wand removed until steady stream of water is
released.
Clogged nozzle. Clean nozzle. See manual page 14.
Water leaking from garden
hose inlet connection.
Garden hose connector is not
fully tightened.
Tighten garden hose connector by turning
clockwise..
TROUBLESHOOTING

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Black & Decker 10BLE-025 and is the answer not in the manual?

Black & Decker 10BLE-025 Specifications

General IconGeneral
BrandBlack & Decker
Model10BLE-025
CategoryPressure Washer
LanguageEnglish

Related product manuals