15
ENGLISH
(Original instructions)
PROBLEM CAUSE CORRECTION
Motor buzzes but fails
to run.
Supply voltage below minimum. Verify that only the pressure washer is running on this cir-
cuit.
System has residual pressure. Turn unit off, squeeze trigger on spray wand to release pres-
sure, then turn unit on.
Voltage loss due to exten-
sion cord.
Plug directly into outlet.
Cleaner not used for long pe-
riods.
Contact your local dealer
No detergent. Detergent container is empty. Add more detergent.
Detergent bottle or suction tube
not properly connected.
Check connections.
Detergent is too thick. Use detergent recommended for use in pressure wash-
ers only.
Filter on detergent suction tube
is clogged.
Run warm water through lter to remove debris.
Damaged or clogged detergent
suction tube.
Remove obstruction or replace detergent suction tube.
Discharge nozzle is obstructed. Blow out or remove debris.
To Next Page
Loading...
