the spanner wrench into the holes of
the outer washer.
Securely tighten the blade retaining
screw by holding the spanner wrench
tighten the blade retaining screw.
REMOVING THE BLADE
protrusions of the spanner wench (8)
into the holes in the outer washer (10).
Loosen and remove the blade retaining
Remove the outer washer (10).
Remove the saw blade (5).
WARNING:
serious personal injury, read, understand
and follow all important safety warnings
and instructions prior to using tool.
GENERAL CUTS (IMPORTANT:
READ SAFETY WARNINGS AND
INSTRUCTIONS. )
GUARD AGAINST KICKBACK
adjustment and set up instructions.
the proper blade for the material to be cut.
9
15
8
10
8
Safety Rules and Instructions).
equipment (See Safety Rules).
Safety Rules).
WARNING: It is important to support
firmly to prevent loss of control which
could cause personal injury. Figure 3
illustrates recommended hand position.
OPERATION
SWITCH
switch (1). The tool will continue to run
as long as the trigger is depressed.
switch (1). There is no provision for
means.
SAWING
WARNING:
serious personal injury,always hold the
tool with both hands.
seconds before starting the cut.
while performing the cut.
HINTS FOR OPTIMUM USE
cannot be avoided, cut on the side
where splintering is acceptable.
e.g. when cutting laminates, clamp a
piece of plywood onto the top of the
POCKET CUTTING (FIG.11)
WARNING: Never tie the blade guard
in a raised position. Never move the saw
may cause the unit to raise up off the
floor, wall, or other flat surface.
cuts at desired depth.
10
15
11
10
8
5
16
11
To Next Page
Loading...
