the spanner wrench into the holes of
the outer washer.
Securely tighten the blade retaining
screw by holding the spanner wrench
tighten the blade retaining screw.
REMOVING THE BLADE
Loosen and remove the blade retaining
WARNING:
serious personal injury, read, understand
and follow all important safety warnings
and instructions prior to using tool.
GENERAL CUTS (IMPORTANT:
READ SAFETY WARNINGS AND
INSTRUCTIONS. )
GUARD AGAINST KICKBACK
adjustment and set up instructions.
the proper blade for the material to be cut.
Safety Rules and Instructions).
8
Safety Rules).
WARNING: It is important to support
firmly to prevent loss of control which
could cause personal injury. Figure 3
illustrates recommended hand position.
OPERATION
SWITCH
as long as the trigger is depressed.
means.
SAWING
WARNING:
serious personal injury,always hold the
tool with both hands.
seconds before starting the cut.
while performing the cut.
HINTS FOR OPTIMUM USE
cannot be avoided, cut on the side
where splintering is acceptable.
e.g. when cutting laminates, clamp a
piece of plywood onto the top of the
POCKET CUTTING (FIG.11)
WARNING: Never tie the blade guard
in a raised position. Never move the saw
may cause the unit to raise up off the
floor, wall, or other flat surface.
cuts at desired depth.
the foot plate on material to be cut.
10
11
10
8
16
9
8
10
11
To Next Page
Loading...
