Black & Decker GH3000 - Troubleshooting Common Issues; Unit Will Not Start; Rapid Line Consumption in Edge Mode; Maintenance and Service Support

12
sure to wind the line on neatly and in layers. Do not crisscross figure S.
• Whenthewoundcuttinglinereachestherecesses(R4),cutthelineanddockitinthe 
spool line slots (R5) .
• Fitthespoolcapontotheapplianceasdescribedin“REPLACINGTHESPOOL”(figures
O, P).
TROUBLESHOOTING
Problem Possible Cause Possible Solution
• Unitwillnotstart. •Cordnotpluggedin. •Plugapplianceintoaworkingoutlet.
  •Circuitfuseisblown. •Replacecircuitfuse.(Iftheproduct
     repeatedlycausesthecircuitfuseto 
    blow,discontinueuseimmediatelyand
     haveitservicedataBlack+Decker
     servicecenterorauthorizedservicer.) 
  •Circuitbreakeristripped. •Resetcircuitbreaker.(Iftheproduct
     repeatedlycausesthecircuitbreakerto
     trip,discontinueuseimmediatelyand
     haveitservicedataBlack+Decker
     servicecenterorauthorizedservicer.) 
  •Cordorswitchis •HavecordorswitchreplacedatBlack
   damaged.  +DeckerServiceCenterorAuthorized
     Servicer
• Cuttinglineisconsumed •Edgingtoofarfrom •Ensureedgingwheelisontheedgeof
 quicklyinedgemode.  edgeofsidewalksor  thesurfaceandthecuttinglineispositioned
   abrasivesurfaces.The  inthegrassordirtareatobeedgednot
   cuttinglineishittingthe  thesidewalkorotherabrasivesurface.
   sidewalkorabrasivesurface.
MAINTENANCE
WARNING: Disconnect the plug from the power source before performing any
maintenance.
CAUTION: ToassureproductSAFETYandRELIABILITY,repairs,maintenanceand
adjustment should be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
1. Keep the air intake slots clean to avoid overheating.
2. Your trimmer line can dry out over time. To keep your line in top condition, store spare
 pre-woundspoolsorbulklineinaplastic,sealablebagwithatablespoonofwater.
3. Plastic parts may be cleaned by using a mild soap and a damp rag.
4. The line cutter on the edge of the guard can dull over time. It is recommended you
 periodicallytouch-upthesharpnessofthebladewithafile.
SERVICE INFORMATION
AllBlack+DeckerServiceCentersarestaffedwithtrainedpersonneltoprovidecustomerswith
efficient and reliable power tool service. Whether you need technical advice, repair, or genuine
factoryreplacementparts,contacttheBlack+Deckerlocationnearestyou.Tofindyourlocal
servicelocationcall:1-800-544-6986orvisitwww.blackanddecker.com