11
becomes dislodged, replace in correct
position before inserting a new spool
as shown in figure R.
and guide the line into the eyelet (P2).
cap and rotate it until you feel it drop
into place. Then push to snap into
place. (When in place, the spool will
turn a few degrees left and right freely).
becoming trapped under the spool.
on the spool housing (figure Q).
in figure Q by depressing lugs and
pressing into spool housing.
NOTE: The line should protrude
approximately 4-13/16 inches (122mm)
from the housing.
R
R1
REWINDING SPOOL (FIGURES S, T)
WARNING: Remove the battery
from the trimmer before making any
assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the
appliance accidentally.
NOTE: USE ONLY .080 inch (2.0 mm)
DIAMETER ROUND NYLON MONO
FILAMENT LINE. Do not use serrated,
heavier or lighter gauge line, as they
will overload the motor and cause
overheating. Using line other than 0.080
inch round line will cause the automatic
feed system to malfunction.
NOTE: Hand wound spools from bulk
line are likely to become tangled more
frequently than BLACK+DECKER factory
wound spools. For best results, factory
wound spools are recommended.
To rewind spool, follow the steps below:
the appliance as described in
“REPLACING THE SPOOL”.
line at about 3/4 inch (19mm) (S1).
upper hole inside of the spool (S2) as
shown in figure S3.
the direction of the arrow on the spool.
Make sure to wind the line on neatly and
in layers. Do not crisscross figure T.
the recesses (S4), cut the line and
dock it in the spool line slots (S5) .
described in “REPLACING THE SPOOL”
(figures P, Q).
S5
S1
S4
S2
S3
S
T
MAINTENANCE
WARNING: To avoid serious injury,
remove the battery from the appliance
before performing any maintenance.
1. Keep the air intake slots clean to avoid
overheating.
2. Your trimmer line can dry out over
time. To keep your line in top condition,
store spare pre-wound spools or bulk
line in a plastic, sealable bag with a
tablespoon of water.
3. Plastic parts may be cleaned by using a
mild soap and a damp rag.
4. The line cutter on the edge of the guard
can dull over time. It is recommended
you periodically touch-up the sharpness
of the blade with a file.
To Next Page
Loading...
