To Next PageTo Next Page
Need help?Do you have a question about the Black & Decker LST136 and is the answer not in the manual?
General| Power Source | Battery |
|---|---|
| Battery Voltage | 40V |
| Cutting Swath | 13 inches |
| Line Diameter | 0.065 inches |
| Battery Type | Lithium-Ion |
Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury.
Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury.
Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury.
Indicates a potentially hazardous situation, which, if not avoided, may result in property damage.
Essential safety rules for using battery chargers and avoiding hazards like shock and fire.
Safe practices for handling, charging, and storing battery packs to prevent damage and hazards.
Steps for plugging in, inserting battery, and identifying charge completion.
Identifies issues like bad batteries or temperature delays via LED patterns.
Battery can remain connected for continuous charge and freshness.
Best temperature range for battery charging and avoiding damage.
Steps to check receptacle and conditions if battery does not charge properly.
Steps to insert battery pack into tool until it clicks and is fully seated.
How to depress the release button and pull the battery pack out of the tool.
Instructions for securely attaching the guard to the trimmer head.
Steps for mounting the auxiliary handle onto the tool's tube.
How to adjust the height and secure the auxiliary handle for optimal balance.
Guidance on switching the tool between trimming and edging functions.
How to set up and use the tool for trimming grass effectively.
Instructions and safety precautions for using the tool as an edger.
Proper technique for swinging the trimmer and maintaining cutting angle.
How to make closer cuts and achieve optimal results when edging.
Instructions for replacing the spool with a Black & Decker AF-100 spool.
Solutions for when the tool runs slowly, including checking spool rotation and line protrusion.
Troubleshooting for when the automatic line feed does not dispense more line.
