12
PROBLEM
Trimmer runs slowly.
Automatic line feed does not feed more
line.
Overfeeding
Line unravels when cap or spool is
removed.
SOLutiOn
The level of trigger depression affects
speed.
freely. Carefully clean it if necessary.
does not protrude more than
approximately 4-13/16 inches
(122mm) from the spool.
If it does, cut it off so that it just
reaches the line trimmingblade.
to approximately 3 inches (76.2mm). To
determine if the line is not feeding, let line
wear past this point.
the spool from the spool housing in the
trimmer head.
on the spool as detailed in figure T. If it is,
unwind the cutting line, then wind it back
on the spool neatly so that the lines do
not cross.
damage. If damaged, replace spool.
approximately 4-13/16 inches (122mm)
from the spool. If insufficient cutting line
is left on the spool, install a new spool of
cutting line.
cut outs in the housing.
until it snaps securely into place.
trimming blade, cut it off so that it just
reaches the blade. If the automatic line
feed still does not work or the spool is
jammed, try the following suggestions:
size and diameter (080 inch (2.00 mm))
- smaller and larger line sizes will affect
the functionality of the auto feed system.
lever in the spool housing can move
freely.
cutting line, then wind it on neatly again.
Replace the spool into the housing.
the tip of the
line (7 inches (177.8mm) from the spool).
Use the edge guide if needed to ensure
proper space is maintained.
10°
angle as shown in figure M1.
holding
slots (figure P) before removing.
Troubleshooting
To Next Page
Loading...
