9
10
9
K
SWITCHING ON AND OFF
hold the lock off button (3), depress
the variable speed trigger (1). The
trimmer’s speed, power, and runtime
depend on how far you press the
switch. Lightly depressing the trigger
will result in lower speed and power,
but longer runtime. Fully depressing
the trigger will result in maximum
speed and power, but shorter runtime.
the trigger and the lock off button.
WARNING: Never attempt to lock the
on/off button in the on position.
L
1
3
OPERATING THE TRIMMER
With the unit on, angle unit and slowly
swing the trimmer side to side as shown
in figure M.
M
angle of 5° to 10°
as shown in figure
M1. Do not exceed
10°(figure M2). Cut
with the tip of the line.
To keep distance
from hard surfaces
use edge guide (10).
Pull the guide out
until it snaps securely
into place
distance of 24 inches (609.6 mm)
between the guard and your feet as
shown in figure M3. To acheive this
distance adjust the overall height of the
trimmer as shown in figure H.
5
O
-10
O
M1 M2 M3
EDGING
Do not use the trimmer to create edges
or trenches.
Guide the trimmer as shown in figure N.
To make a closer cut, slightly tilt the
trimmer.
N
HELPFUL CUTTING TIPS
Use the tip of the string to do the
cutting; do not force string head into
uncut grass. Use edge guide along
such things as fences, houses and
flower beds for best practices.
string wear, even breakage. Stone and
brick walls, curbs, and wood may wear
string rapidly.
ground or other surfaces.
and do not exceed 12 inches (304.8
mm) high.
being cut; this is the best cutting area.
unit from the right to left. This will avoid
throwing debris at the operator.
wood moldings, siding, and fence posts
can easily be damaged by the string.
CUTTING LINE / LINE FEEDING
Your trimmer uses .080 inch (2.00 mm)
diameter, ROUND nylon line. During
use, the tips of the nylon lines will
become frayed and worn and the special
self feeding spool will automatically feed
and trim a fresh length of line. DO NOT
BUMP unit on ground in attempt to feed
line or for any other purposes.
Cutting line will wear faster and require
more feeding if the cutting or edging is
To Next Page
Loading...
