BEVEL ADJUSTMENT
(Turn OFF and UNPLUG saw)
To adjust the bevel angle, loosen the screw, as shown in Figure 2 and adjust
the bevel
left
or
right as desired using the handy protractor scale stamped
in the shoe. Although
this
scale is a good reference, we recommend test
cutting
in scrap material before attempting any finish work.
BLADE INSTALLATION
(Turn
OFF
and UNPLUG saw)
FIGURE 2
To install a blade, loosen the blade clamp screw with a screwdriver,
as
shown
in
FIGURE
3.
Insert the saw blade all the way,
as
shown in the figure and
tighten the screw. To remove the blade, simply loosen the screw.
FIGURE 3
To Next Page
Loading...
