DSR during ALB
ON OFF
REMOTE TEST
ENABLE DISABLE
CD LEVEL LEASED
-26 -33 -43
TEST OPTIONS
DSR RMT
CTS to EIA
NORM RTS TRUE
CD to EIA
NORM TRUETOGGLE
DSR to EIA
NORM TRUE XOVER
EIA
CTS CD DSR
<1>
SETUP
TEST EIA MODEM
<4>
EIA
DTR ALBT RDLT
<2>
DTR from EIA
NORMAL TRUE
RDL - DTE Ctrl'ed
ENABLE DISABLE
ALB - DTE Ctrl'ed
ENABLE DISABLE
TM to EIA
NORMAL TRUE
EIA
TM
<3>
CARRIER DET.
LEASED DIAL
LVL
CD LEVEL DIAL
-26 -33 -43
MODEM SETUPS
CDLVL TXLVL
<1>
TRANSMIT LEVEL
LEASED DIAL
TX LEVEL
DEC INC
0 dBm
TX LEVEL (DL)
PROG PERMIS
MODEM SETUPS
SQ COMEQ TREL
<2>
TRELLIS CODE
ENABLE DISABLE
SIGNAL QUALITY
10^3 10^5
MODEM SETUPS
TXCLK T1 RETRN
<3>
TRANSMIT CLOCK
INT RX-CLK EXT
AUTO-RETRAIN
ENABLE DISABLE
T1 timer: 0.8sec
DEC INC
MODEM SETUPS
ANS/ORG ANSFREQ
<4>
ANSWER TONE
2225Hz 2100Hz
ANS/ORG DEFAULT
ANSWER ORIGINATE
MODEM SETUPS
FP SPK SPKVOL
<5>
SPEAKER VOLUME
LOW MEDIUM HIGH
SPEAKER CONTROL
OFF TILL-CD ON
FP
ENABLE DISABLE
MODEM SETUPS
GUARD V13
<6>
V.13
DEC INC
OFF
MODEM SETUPS
CARR CTS RTS-CTS
<8>
PASSWORD
CHANGE CLEAR
SETUP
PHONE AUTO LCDI
<5>
301-555-1234
DEC CTRL INC
LCD INTENSITY 5
DEC INC
SETUP
SUMMARY
<6>
PRI
0011214E0 999 99
addr
AT PROFILES
0 1 &Y0
DEC SKIP INC
CONFIRM
ATbefImqvwxy
0102101341
AT&c
SETUP
TYPE LINE SPEED
<1>
LINE TYPE
2W-D 2W-LL 4W-LL
V42 CONTROL
V42 SEL BUFFER
<1>
BUFFER SELECT
ENABLE DISABLE
V42 SELECTION
PROTOCOL V42bis
V42
MODE CLASS BREAK
V42 MODE
OFF MANDAT AUTO
LAPM/MNP
DEC INC
SETUP
V42 ADDR DIALER
<2>
V42 CONTROL
DTE FLOW
<2>
V.42bis
ENABLE DISABLE
ADDRESS:
DEC INC
999,999
PASSTHRU MODE
ENABLE DISABLE
SETUP
ANSWER DATA DISC
<3>
DISCONNECT
RX TX
<1>
AUTO-ANSWER
ENABLE DISABLE
RX SPACE DISC'T
ENABLE DISABLE
TX SPACE DISC'T
ENABLE DISABLE
DATA FORMAT
TYPE LENGTH PAR
DATA FORMAT
SYNC ASYNC
DISCONNECT
CARR. CURR. RTS
<2>
CURRENT DISC'T
ENABLE DISABLE
CARRIER DISC'T
ENABLE DISABLE
RATE
DOWN UP
MAIN MENU
RESET RATE
<3>MAIN MENU
SETUP TEST RMT
<2>MAIN MENU
TALK QUICK DIAL
<1>
****
SPEED TYPE
DEC INC
V32
MIN RATE:
DEC INC
0-300
MAX RATE:
DEC INC
19,200
FLOW CONTROL
DTE-DCE DCE-DTE
<1>
DTE SPEED:
DEC INC
38,400
MNP CLASS
DEC INC
5
FLOW CONTROL
PASSTHRU
<2>
DCE-DTE
NONE CTSon/off
<1> DCE-DTE
DC1/DC2 DC1/DC3
<2>
DTE-DCE
DEC INC
RTS
RTS DISC'T
DEC INC
OFF
PARITY:
DEC INC
NONE
CHAR LENGTH
91110
(Resets
modem)
This screen is displayed only
if V.32bis mode is selected.
* See reverse side of chart.
Set
automatically
in Hayes
mode only.
Set automatically in
Hayes mode only.
Hayes mode only: Use S register
S10 to change these options.
These screens are only displayed on models that support these
options. MODEM SETUPS screens may be numbered differently.
These screens allow for quick option selections.
(Use arrow pushbuttons to view full display.)
For further explanation, see Instruction Manual,
appendix C, Summary Setup.
Use INC (increase) and DEC (decrease) to
cycle through digits (0-9); use CTRL to cycle
through dialing control characters(T, *, #, etc.).
Checksum.
If this number
changes, at
least one
option has
been
changed.
Continued below
Continued
from
BREAK:
DEC INC
NDT/NEXP
COMPR EQUAL
DEC INC
T-III
GUARD TONE
550Hz 1800HzOFF
PHONE CELL:
DEC PROG INC
00
NO AUTO-RECOVERY
DEC INC
RETURN:
DEC INC
OFF
AUTO-RECOVERY
SELECT RETN TEST
TEST EVERY 20min
DEC INC
MODEM SETUPS
PSWD
<7>
TRAIN
CARRIER
SWITCH CONSTANT
CTS DELAY: 0 ms
DEC INC
CTS
RTS ON
TRAINING LENGTH
LONG SHORT TER
V.32bis/14.4M
V.32 V4.51/3.25
D TR MR RS CS
9600 TM ER CD RD
TD LINE LEVELS. dBm
TX=-09 RX=-24
ECHO: msec
020 1.0
Hz CHANNEL FREQ
OFFSET: 1.0 Hz
THROUGHPUT
15000 BPS
QUALITY 000 PKT: SIZE
255 0233 00
ERTX MODE
V42bis 38400
RATE
Power-on Screen
Software revision levels (may be
different than shown here.)
STATUS SCREENS
EIA status screen: Not all abbreviations will be present
at same time. (R in upper left corner indicates an incoming ring.)
Bar graph
Except for the power-on screen, the data shown on these screens will change,
depending on external conditions and the modem's operational status.
DTE-DCE
DEC INC
CTS
The Quick Setup screens are used to quickly select pre-set modem configurations for various applications.
QUICK SETUP MENU
QUICK SETUP
2-W DIAL (HAYES)
<1> QUICK SETUP
V25 DIAL (Async)
<2> QUICK SETUP
V25 DIAL (Syn_c)
<3> QUICK SETUP
V25 DIAL (Syn_b)
<4> QUICK SETUP
2-W DIAL (DUMB)
<5> QUICK SETUP
2-W LEASED (ORG)
<6> QUICK SETUP
2-W LEASED (ANS)
<7> QUICK SETUP
4-W LEASED (ORG)
<8> QUICK SETUP
4-W LEASED (ANS)
<9> QUICK SETUP
4-WLL V.33
<10> QUICK SETUP
2-W DIAL (208)
<11> QUICK SETUP
2-W DIAL V32/208
<12> QUICK SETUP
4-WLL V.29
<13> QUICK SETUP
V.29 FAST MASTER
<14> QUICK SETUP
V.29 FAST SLAVE
<15>
DIALER
DEC INC
HAYESSPEED LIMIT
MAX MIN
SUMMARY
SETUPS S-REG
314E
AT
S-REG
DEC INC
00:01
ATbefImqvwxy
0102101341
AT&c
Pushing 3
changes
from &Y0
to &Y1
Appendix E: LCD Flow Chart
DCE-DTE
To Next Page
Loading...
