20
SERVSWITCH BRAND CAT5 KVM EXTENDER FOR SUN
If you are conducting a same-room test prior to your final installation, as we
recommend—see Section 6.1—set the jumpers as appropriate for the length of the
test cable first; then, if the units pass the test, reset the jumpers for your actual
installation length.
For cable lengths of up to 330 ft. (100.6 m), set all three to OFF
(
).
For 330 to 655 ft. (100.6 to 199.6 m), set all three to A (
).
For 655 to 1000 ft. (199.6 to 304.8 m), set all three to B (
).
Figure 5-1. The Remote Unit’s main PCB,
showing the cable-length jumpers and DIP switch.
NOTE
The default Sun resolution is 1152 x 900. If your CPU is outputting video
at this resolution, you should set all the cable-length jumpers to A if
your cable is longer than 260 ft. (79.2 m). You might not be able to get
good video at all at this resolution if you run cable farther than 430 ft.
(131.1 m).
KEYBOARD
AND MOUSE
MONITOR
POWER
ON 1 2 3 4
Cable-Length Jumpers
DIP-Switch SW1
INTER-
CONNECT
BRIGHT-
NESS
FOCUS
JP3
JP4
JP5
To Next Page
Loading...
