24
SERVSWITCH BRAND CAT5 KVM EXTENDER FOR SUN
Figure 6-3. Attaching a monitor, keyboard, and mouse to the Remote Unit.
6.2.5 A
TTACHING A
KVM S
WITCH TO THE
R
EMOTE
U
NIT
Making sure that the KVM switch is powered OFF, attach a Sun/VGA type CPU
Cable (see Section 4.2.4 for product codes) from one of the switch’s CPU ports to
the matching ports on the Remote Unit, as shown in Figure 6-4.
Figure 6-4. Attaching a KVM switch to the Remote Unit.
6.3 Finishing Your Installation
To finish installing a KVM Extender for Sun after attaching devices to it as
described in Section 6.2, take these steps:
1. Interconnect the Remote Unit and the Local Unit by running CAT5 cable
between their front-panel modular jacks. See Section 4.2.5 for specifications
for this cable.
2. Turn the Brightness and Focus dials on the Remote Unit counterclockwise, by
hand or with a screwdriver, as far as they will go.
CPU Cable
(EHN515)
ServSwitch Ultra
(KV5016FA-R2)
To Next Page
Loading...
