40
SERVSWITCH BRAND CAT5 KVM EXTENDER FOR SUN
Appendix B: Rackmounting
If you’d like to mount any of your ServSwitch Brand CAT5 KVM Extender for Sun
system’s Local or Remote Units in a 19" rack, use a two-bracket rackmount kit like
the one shown below (product code RMK19U-R2).
To use a kit to mount an extender, take these steps, referring to the illustration
below:
1. Unscrew and keep the two screws on each side of the unit’s case.
2. Match up the two holes in the “unit end” of each kit bracket with the two now-
vacant screwholes on each side of the unit, then fasten the brackets to the
unit with the screws you removed in step 1.
3. Once you’ve attached both brackets, match the holes in the “rack end” of
each bracket to an appropriate set of matching holes on your equipment
rack. Screw the unit assembly to the rack using your own screws, bolts, or cage
nuts (not included).
To Next Page
Loading...
