To Next PageTo Next Page
Need help?Do you have a question about the Black Horse Model CORSAIR and is the answer not in the manual?
General| Brand | Black Horse Model |
|---|---|
| Model | CORSAIR |
| Category | Toy |
| Language | English |
Install rubber grommets and brass eyelets onto servos; remove covering.
Install the aileron control horn as pictured.
Thread clevis, prepare servo arm, and bend pushrod wire.
Install the flap servos into the wing as pictured.
Install the flap control horn using epoxy glue.
Install the flap linkages as shown in the pictures.
Install the engine mount onto the fuselage.
Fit the engine onto the mount and connect the throttle pushrod.
Assemble stopper with fuel lines, bending tubes for vent and fueling.
Install elevator servo to the tray using mounting screws.
Cut out switch hole and secure switch.
Plug in leads, wrap and secure receiver/battery.
Fit and attach the aluminum wing dihedral brace.
Recommended control throws for ailerons, flap, elevator, and rudder.
Check batteries, bolts, glue, balance, antenna, and propeller before flying.
